1. The aluminum electrolytic capacitor has a two-polar structure (see the mark on the capacitor body). Pay attention to the polarity when installing, and do not install it. AC or reverse Application of the voltage may cause a short circuit or damage to the capacitor: the polarity in the AC circuit m
The capacitor can be installed in two ways: indoor installation and outdoor installation. The installation methods should meet the following requirements.For Outdoor installation：The following four aspects should be paid attention to when installing capacitors outdoors.like run capacitorInstallation
Running capacitors are used to continuously adjust the current or phase shift of the motor winding to optimize the torque and efficiency of the motor. Because it is designed for continuous operation, the failure rate is much lower than that of the starting capacitor.Start capacitors give a large cap
As an indispensable part of our daily electrical components, capacitors are widely used in isolation, coupling, bypass, filtering, tuning loops, energy conversion, control circuits and so on. Most of the causes of electrical product damage may be caused by capacitor damage, so how do we test the qua
The starting capacitor is mainly used for the starting of motors with high torque, such as single-phase asynchronous motors and three-phase asynchronous motors in the single-phase power supply system such as air conditioner, refrigerator, compressor and water pump.Then how do start capacitors work?